Logo

C0701 BMW Fault Code

Check C0701 OBD Fault Code Reason
Description:

The issue covered by the bulletin involves a power steering noise/whine or fluid leak from the power steering pump, gear or high pressure side power steering hose during extreme low outdoor temperature operation.

C0701 Code Symptoms :

See C0701 in engine

The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. C0701 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.

Diagnosis And Repairing C0701

C0701 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to fix C0701 code ?

See C0701 repair manual
  • Continuous oil flow to the VCT piston chamber
  • Exhaust gas leaks
  • Engine Control Module (ECM)
  • Faulty Variable Camshaft Timing (VCT) position solenoid

Gear changes are accomplished by a command from the BMW TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

BMW Cars that meet C0701 error